VisionStat Plus MA-BCKS-7.0 Manual de usuario descargar pdf (Pagina 10)

10

Mobile Awareness

Installation: Cameras (Continued)

If the Camera cable will run through the

vehicle body (see Figure 12), drill a 20mm

hole in order to pass the 4-pin connection

through. Once this connection is made, it may

be placed inside the vehicle body for

additional protection. The rubber grommet on

the Camera’s cable can be used to plug the

20mm hole. Seal the hole properly with

waterproofing compound, as well as

anywhere cables run through openings in the

vehicle body.

The Camera can be angled by loosening the

6 hex screws, 3 on each side, of the Camera.

Once the desired angled is achieved, retighten the 6 hex screws to secure the

Camera.

Once you have determined the most

effective mounting location, remove

the Frame Release Screws (2 each)

that hold the cover onto the Side

Camera Frame. Place the included

Rubber Insulating Pad in the

location where you plan to mount

the Camera and use it as a template

to mark and drill the (4 each)

mounting holes. Follow by drilling

the hole to pass the 4-pin Camera

cable connector through the vehicle.

Connect the included extension cable

(s) prior to mounting the Camera to

the Side Camera Frame. This will

allow you to thread the metal

connectors together, tighten them

securely and then slide the rubber

boot completely over the mated

connectors. This will assure a

watertight and trouble free connection.

When connecting to the Wiring

Harness, the left side Camera should

be connected to the WHITE Channel

One 4-pin Connector and the right

side Camera to the BLUE Channel

Two 4-pin Connector, via the included

extension cables.

Fig 12: Hex Screws on Side Camera

Installation: Side Cameras

Fig 13: Side Camera Mounting Bracket

Fig 14: Side Camera Mounting Bracket

1 2 ... 5 6 7 8 9 10 11 12 13 14 15 16

Comentarios a estos manuales

Sin comentarios